ADTRAN NetVanta 160 Manual de Instruções descarregar pdf (Página 198)

Section 5, DLP-021 NetVanta 2000 Series System Manual

5. Click Yes to reboot the NetVanta 2000 series and restore all parameters to factory default settings.

6. Complete the steps in

DLP-001 to access the

NetVanta 2000 series

unit.

Perform Steps Below in the Order Listed - Hardware Default

1. Make sure the NetVanta 2000 series unit is powered up.

2. On the rear panel of the NetVanta 2000 series unit there is a factory default pinhole located between

the LAN and WAN interfaces. Push the factory default pinhole for 1-2 seconds to restore the LAN

interface factory settings.

Follow-up Procedures

Once this procedure is complete, return to the procedure which referred you to this DLP and continue with

the tasks indicated there.

Performing a factory default using hardware only restores the LAN interface

parameters to default state. The DHCP server will be enabled and the LAN interface

will be given an IP address of 10.10.10.1.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 209 210

Sem comentários

ADTRAN NetVanta 160 Manual de Instruções Página 198