Adtran NetVanta 300 Series Manual do Utilizador descarregar pdf (Página 26)

Unit Installation NetVanta 300 Series Hardware Installation Guide

Getting Started

Connect to the NetVanta 300 Series Unit

1. Connect the NetVanta 300 Series unit to the PC using one of the ETHERNET ports on the back of

the unit and the appropriate Ethernet cable.

2. Supply power to the PC and the NetVanta 300 Series unit and begin the operating system boot up

process. During boot up, the PC will obtain an IP address from the NetVanta 300 Series unit

DHCP server. By default, both the DHCP and HTTP servers are enabled. The default IP address is

10.10.10.1.

3. Enter the unit’s IP address in your browser address line. The default IP address is

10.10.10.1.

4. You will then be prompted for the username and password (the default settings are

admin and

password).

5. The initial GUI screen appears.

6. Click on

Getting Started in the System menu on the left side of your screen and follow the

on-line instructions.

Configure the ATM PVC

1. Click on the Getting Started link under the System menu. This will bring up a side bar page.

2. Click on

Step 1 - Configure the Public Interface at the top of the side bar page to open the ATM

PVC

page.

3. Fill in the PVC number and select an

Interface Mode. This is usually PPP or PPPoE; however, if

IP Routing is chosen, you will need to enter an IP address.

4. Click

Apply. If PPP or PPPoE is selected as the Interface Mode, you will be taken to the PPP

page after clicking

Apply. Here you will need to select the type of authentication needed,

authentication passwords, and the

Address Type. In most cases you will want the Address Type

to be

Negotiated. Click Apply when all the information is complete.

The 10/100BaseT Ethernet interface MUST NOT be metallically connected to interfaces

which connect to the Outside Plant or its wiring. This interface is designed for use as an

intrabuilding interface only. The addition of primary protectors is not sufficient protection

to connect this interface metallically to OSP wiring.

For security purposes, you should set up an admin password immediately. Use the

Passwords page of the Web GUI to change this password.

By default, the NetVanta 300 Series unit comes with an ADSL and an ATM port already

configured and enabled. The service provider should provide a PVC (VPI / VCI) number

which will be used to configure the ATM PVC.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 32

Comentários a estes Manuais

Sem comentários

Adtran NetVanta 300 Series Manual do Utilizador Página 26

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Adtran NetVanta 300 Series