ADTRAN FNID Informações Técnicas descarregar pdf (Página 46)

Troubleshooting Integrated Traffic Monitoring

Use the show ip flow interface command to display configuration parameters for each interface on the

AOS product. This command displays which interfaces are configured for ITM, whether they are enabled

for ingress or egress monitoring, and whether they are configured for sampling. The following is sample

output from an AOS product with an Ethernet interface and a point-to-point interface configured for ITM:

#show ip flow interface

eth 0/1

ip flow ingress

ppp 1

ip flow ingress

ip flow egress

This display informs you that the Ethernet interface on port zero/slot one (eth 0/1) is set to monitor ingress

traffic flows, and that point-to-point interface one (ppp 1) is set to monitor both ingress and egress traffic

flows.

Use the show ip flow top-talkers commands to display information pertinent to ITM Top Traffic

configuration on your AOS product and to reveal possible problems in the configuration.

Use the show ip flow top-talkers [hour | day] [detail] command to view the list of IP addresses that

generated the most IP traffic during the current interval. Using only the show ip top-talkers command

results in the display of data from the configured interval (5-, 10-, or 15-minute) currently being

accumulated. If the hour keyword is specified, the data from the hour currently being accumulated is

displayed. If the day keyword is specified, the data from the 24-hour period currently being accumulated is

displayed. Using the optional detail keyword displays the information for previous intervals as well as the

current interval.

1 2 ... 41 42 43 44 45 46 47 48 49 50

Sem comentários

ADTRAN FNID Informações Técnicas Página 46