ADTRAN Stub Routing Guia do Utilizador descarregar pdf (Página 93)

Table 6: show interfaces Gigabit Ethernet Output Fields (continued)

Level of OutputField DescriptionField Name

extensive(10-Gigabit Ethernet interfaces, WAN PHY mode) SONET error information:

• Seconds—Number of seconds the defect has been active.

• Count—Number of times that the defect has gone from inactive to active.

• State—State of the error. Any state other than OK indicates a problem.

Subfields are:

• BIP-B1—Bit interleaved parity for SONET section overhead

• SEF—Severely errored framing

• LOL—Loss of light

• LOF—Loss of frame

• ES-S—Errored seconds (section)

• SES-S—Severely errored seconds (section)

• SEFS-S—Severely errored framing seconds (section)

WIS section

extensive(10-Gigabit Ethernet interfaces, WAN PHY mode) Active alarms and defects,

plus counts of specific SONET errors with detailed information.

• Seconds—Number of seconds the defect has been active.

• Count—Number of times that the defect has gone from inactive to active.

• State—State of the error. State other than OK indicates a problem.

Subfields are:

• BIP-B2—Bit interleaved parity for SONET line overhead

• REI-L—Remote error indication (near-end line)

• RDI-L—Remote defect indication (near-end line)

• AIS-L—Alarm indication signal (near-end line)

• BERR-SF—Bit error rate fault (signal failure)

• BERR-SD—Bit error rate defect (signal degradation)

• ES-L—Errored seconds (near-end line)

• SES-L—Severely errored seconds (near-end line)

• UAS-L—Unavailable seconds (near-end line)

• ES-LFE—Errored seconds (far-end line)

• SES-LFE—Severely errored seconds (far-end line)

• UAS-LFE—Unavailable seconds (far-end line)

WIS line

Chapter 5: Monitoring Commands

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 131 132

Sem comentários

ADTRAN Stub Routing Guia do Utilizador Página 93