ADTRAN NetVanta 7000 Series Manual do Utilizador descarregar pdf (Página 7)

NetVanta 7000 Series Release Notes R10.8.1 Important Notices

These files can be downloaded from http://www.adtran.com/support, select Software Downloads, and

choose the appropriate phone model from the IP 700 Series. Contact ADTRAN Post Sales Technical

Support at (888) 423-8726 or email: [email protected], if you are unable to download these files.

Important Notices

The following important notices are provided in addition to the previous Supported Platforms, Hardware

Requirements and Limitations, and Software Requirements and Limitations sections to ensure successful

deployment.

Upgrades to AOS version R10.8.0 and Later

Beginning with AOS version R10.8.0, the syntax of certain commands was modified from previous AOS

versions (such as AOS R10.5.x, R10.7.x) by either removing or adding the ip keyword. In general, when

the ip keyword appears in a command, it signifies that the command is only applicable to IPv4

functionality. As more features introduce IPv6 support, the ipv6 keyword is added to signify the command

is only applicable to IPv6 functionality. The ip keyword has been removed from several commands to

signify that the command has both IPv4 and IPv6 functionality.

Due to this syntax change, downgrading a NetVanta 7000 Series product configured in AOS version

R10.8.0 or higher to a previous AOS version (such as AOS R10.5.x, R10.7.x), could cause service

disruption because the new syntax might not be recognized by the previous version. Upgrading a unit from

an older AOS version to AOS version R10.8.0 or later will not cause service disruption because both the

old and the new syntaxes are accepted. It is recommended that a full copy (data and voice settings) of

the configuration be saved prior to upgrading to AOS R10.8.0 and above. This can be done from the

Utilities > Configuration page in the GUI.

For more information on specific commands, refer to the AOS Command Reference Guide

available at

https://supportforums.adtran.com

Please note that the NetVanta 7000 series does not support IPv6 at this time. If you envision needing any

IPv6 features natively on the NetVanta 7000 series, then contact your ADTRAN representative with your

request. In general, we recommend using an IPv6 capable ADTRAN router with the NetVanta 7000 series

for any IPv6 features.

Default Firewall Configuration Changes

Changes were made to the default firewall configuration to increase security of voice platforms when

connected to the Internet. These changes can impact remote phones and SIP trunking applications, but do

not impact local phones on the NetVanta 7000 Series.

• In AOS versions A2.01.00 through A2.03.00.SC, the default Public access control policy (ACP) allowed

SIP traffic (destined for UDP port 5060) inbound. For AOS A2.04.00.SC and above, this traffic is no

longer allowed by the factory default configuration. Instead, the installer is required to selectively

customize the Public ACP to allow SIP traffic from remote sites and SIP trunking providers.

• Units that were shipped with AOS versions through A2.03.00.SC contain a default configuration that

allows inbound SIP traffic (destined for UDP port 5060). These configurations should be modified before

Legacy Polycom IP 430, IP 501, IP 601, IP 4000

phones

3.1.8 4.1.2b

1 2 3 4 5 6 7 8 9 10 11 12 13

Sem comentários

ADTRAN NetVanta 7000 Series Manual do Utilizador Página 7