Adtran 1000R Series Manual do Utilizador descarregar pdf (Página 112)

Command Reference Guide Enable Mode Command Set

debug gvrp vlans <vlan number>

Use the debug gvrp vlans command to see debug messages showing all GARP VLAN Registration

Protocol (GVRP) VLAN changes. Debug messages are displayed (real time) on the terminal (or Telnet)

screen. Use the no form of this command to disable the debug messages.

Syntax Description

<vlan number> Optional. Displays debug messages showing all GVRP-related VLAN changes for

this VLAN only. Range is 1 to 4094.

Default Values

By default, all debug messages in the AOS are disabled.

Applicable Platforms

This command applies to the NetVanta 300, 1000, and 1000R Series units.

Command History

Release 8.1 Command was introduced.

Functional Notes

With GVRP enabled on many ports, this command can produce a lot of output. To see these messages

just for individual interfaces, refer to the command

debug gvrp interface <interface> [bpdus | vlans] on

page 111

Usage Examples

The following example displays debug messages showing GVRP-related VLAN changes for VLAN 1:

>enable

#debug gvrp vlans 1

2000.07.31 22:05:42 GVRP VLANS: Creating dynamic VLAN 20

2000.07.31 22:05:42 GVRP VLANS.eth 0/24: Dynamically adding port to VLAN 20

2000.07.31 22:05:56 INTERFACE_STATUS.eth 0/24 changed state to down

2000.07.31 22:06:08 GVRP VLANS.eth 0/24: Dynamically removing port from VLAN 20

2000.07.31 22:06:08 GVRP VLANS: Last port removed from VLAN 20, destroying VLAN

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 136 137

Sem comentários

Adtran 1000R Series Manual do Utilizador Página 112