ADTRAN TRACER 6000 SERIES Guia de Resolução de Problemas descarregar pdf (Página 91)

DLP-1 Connecting a VT100 Terminal or PC to the CRAFT Port

Introduction

TRACER 64x0 management and provisioning are facilitated by a series of intuitive menus that are

accessible on a computer screen. Connecting either a VT100 terminal or a PC with terminal emulation

software to the

CRAFT interface (DB-9) on the front of the unit allows access to TRACER menus and

management features. This section specifies how to connect the VT100 terminal or PC to the TRACER

64x0.

Prerequisite Procedures

The TRACER 64x0 must be powered up for terminal communication to function.

Tools and Materials Required

• A VT100 compatible terminal or PC with terminal emulation software

• An appropriate cable to connect the TRACER 64x0 to a terminal

To prevent electrical shock, do not install equipment in a wet location or during a

lightning storm.

Electronic equipment can be damaged by static electrical discharge. Before handling it,

put on an antistatic discharge wrist strap to prevent damage to electronic components.

Place equipment in antistatic packing material when transporting or storing. When

working on equipment, always place it on an approved antistatic mat that is electrically

grounded.

1 2 ... 86 87 88 89 90 91 92 93 94 95 96 ... 131 132

Sem comentários

ADTRAN TRACER 6000 SERIES Guia de Resolução de Problemas Página 91