ADTRAN 1204006L1 Manual do Utilizador descarregar pdf (Página 37)

61200.175L1-1 FSU 5622 ESP User Manual 21

Chapter 3. Operation

VT 100 Terminal Connection and Operation

To control the FSU 5622 ESP using a VT 100 terminal, perform

the following procedure:

1. Set the FSU 5622 ESP baud rate to match the terminal

through the front panel. Select 1 CONFIG, then 6 CON-

TROL PORT.

2. Using the provided VT 100 terminal adapter cable, connect

the COM port of a VT 100 compatible terminal or equivalent

to the eight-pin modular jack labeled CONTROL on the rear

of the FSU 5622 ESP. This connection is used for both local

and remote configuration.

3. Open the connection and press Enter repeatedly until the

4. Select LOCAL LOGIN to configure the FSU 5622 ESP unit

connected to the terminal. Select REMOTE LOGIN to

configure a remotely located FSU 5622 ESP unit. For remote

applications, enter the DLCI (data link connection identifier)

number of the remote unit by pressing 1, Enter, the DLCI

number, and Enter again. Next select BEGIN REMOTE

SESSION by pressing 2 and Enter.

5. Enter the password. The factory default password is adtran.

The Main menu will appear (Figure 3-4).

6. Make selections by entering the number corresponding to

the chosen parameter. Press ESC to return to the previous

screen.

In the upper right-hand corner of the VT 100 screen, LOCAL or

REMOTE is displayed, indicating which unit the current screen

represents. See Figure 3-3.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 174 175

Sem comentários

ADTRAN 1204006L1 Manual do Utilizador Página 37