ADTRAN 1204006L1 Manual do Utilizador descarregar pdf (Página 68)

52 FSU 5622 ESP User Manual 61200.175L1-1

Chapter 6. DTE Port Configuration

Protocol Options

Signaling Type (SIGNAL)

Set the signaling type for the DTE port to match the signaling

type of the connected DTE device. Choices are none, LMI, ANSI

T1.617-D, and ITU-T Q.933-A. If none is chosen, the signaling

state for the DTE port is always up.

T392

Set the timeout between polling intervals. This parameter needs

to be a few seconds longer than the T391 setting of the attached

frame relay device.

N392 and N393

These parameters define the error threshold for the UNI formed

by the FSU 5622 ESP DTE port and the attached frame relay

device. If the error threshold is met, the signaling state status is

changed to down, which indicates a service-affecting condition.

This condition is cleared once N393 consecutive error-free events

are received. N392 defines the number of errors required in a

given event window, while N393 defines the number of polling

events in each window.

For example:

If N392=3 and N393=4, then if three errors occur within any four

events the interface is determined inactive.

The status of the connection can be viewed in the Status menu

under DTE Port Signaling State. The status will return to active

once the threshold is no longer exceeded.

Guidelines for Configuring IP Addr, Subnet Mask, and Mng DLCI

If the attached router or FRAD is used to route SNMP/TELNET

frames to the FSU 5622 ESP, set the Management DLCI to a

unique value that identifies the virtual circuit between the

router/FRAD and the FSU 5622 ESP. The router/FRAD must

also be configured to route the FSU 5622 ESP IP address to this

DLCI. The IP address and subnet mask for the DTE port must

also be set.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 174 175

Sem comentários

ADTRAN 1204006L1 Manual do Utilizador Página 68