ADTRAN TA 544 Manual de Instruções descarregar pdf (Página 116)

Section 5 DLP-6 Total Access 544R System Manual

1. Connect the computer to the unit’s CRAFT port as shown in DLP-1, Connecting the Terminal or PC to

the CRAFT Port.

2. Log in to the unit as shown in DLP-2, Logging in to the System.

3. Select S

YSTEM CONFIG, MANAGEMENT, and TELNET ACCESS.

4. Right arrow to A

UTHEN METHOD and press <Enter>. Select PASSWORD, RADIUS, PASSWORD/RADIUS, or

ADIUS/PASSWORD and press <Enter>.

5. Verify the T

ELNET ACCESS is set to ON. Down arrow to select USER LIST and press <Enter>.

The following screen will appear.

6. Use the right arrow key to select the NAME field; press <Enter>. Enter a username to be used for

Telnet logins.

7. If P

ASSWORD was selected for the AUTHEN METHOD in Step 4, right arrow over to PASSWORD; press

<Enter>. Enter a password to be used for Telnet logins.

8. Use the right arrow key to select I

DLE TIME (MINS); press <Enter>. This field defines the amount of

time in minutes the Telnet session may be idle before the user is logged off. The range is 1-255. The

default value is 10 minutes. Enter the appropriate I

DLE TIME.

9. Use the right arrow key to select L

EVEL. Select the appropriate security level. For security level

definitions, reference DLP-3, Adding/Removing Telnet Users and Changing Password Security Levels.

10. This completes the addition of one Telnet user. Repeat Steps 1-9 for each user needing Telnet access.

11. Press <Ctrl + L> to log out of the unit.

Perform Steps Below in the Order Listed

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 161 162

Sem comentários

ADTRAN TA 544 Manual de Instruções Página 116