ADTRAN TA 544 Manual de Instruções descarregar pdf (Página 93)

Total Access 544R System Manual Section 4 SHDSL RCU ATM User Interface Guide

Appendix C. RFC 1483 Quick Start (Bridging)

The Total Access 544R allows for complete integration of data delivery from one compact platform.

To configure a Total Access 544R for Bridging, you need to know the VPI values for the data circuit on

your network.

Bridging

Step Action

From the Total Access 544R main menu, select the L2 PROTOCOL >

NTERFACES menu. (Here you set up the ATM network.)

2. Select the ATM CONFIG menu located under the main CONFIG field.

3. Enter the IDLE CELLS format for your network.

4. Set DATA SCRAMBLING appropriately for your network.

Back all the way out to the top level Total Access 544R menu, and then

select the L2 P

ROTOCOL > CONFIG for the ETH menu.

6. From the CONFIG menu, you will set the MODE to BRIDGE ALL.

Select the ROUTER > CONFIG > INTERFACE > SETUP (ETH) menu, enter

your LAN configuration under P

RIMARY IP.

Enter your LAN IP ADDRESS and SUBNET MASK information.

For this example, the IP ADDRESS is 192.168.1.2, the SUBNET MASK is

255.255.255.0.

Arrow back to the main menu, and select the L2 Protocol Interfaces

menu and then the Config > PCV Config menu. Enter your data PVC

information here.

10.

Create a new PVC by entering the menu and press <i> under NUM field.

Enter your VPI and VCI values.

11.

Arrow back to the top level Total Access 544R menu to activate your

changes.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 161 162

Sem comentários

ADTRAN TA 544 Manual de Instruções Página 93