ADTRAN TA 544 Manual de Instruções descarregar pdf (Página 98)

Section 5 DLP-1 Total Access 544R System Manual

1. Connect a VT100 terminal to the unit.

2. Connect a PC emulating a VT100 terminal to the unit.

3. Most personal computers or laptops can run communications software that will emulate a VT100

terminal. Windows programs such as Terminal

or Hyperterminal

are two such examples in the

Windows format. However, there are many other adequate, commercially available software packages

which will allow your PC or laptop to emulate a VT100 terminal. Certain configuration items must be

set on a PC or laptop for it to act as a VT100 terminal for the unit.

4. Press <Enter> or <Ctrl + R> until the Login menu appears on screen.

You are now ready to log in to the unit, as described in DLP-2, Logging in to the System.

Perform Steps Below in the Order Listed

• Set the parameters of the VT100 terminal to:

– 9600 baud rate

– 8 data bits

– No parity

– 1 stop bit

– No flow control

• If the terminal has a parallel setting, disable it and use serial port.

• Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by

using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make the connection to the VT100

terminal as appropriate for your equipment.

• Set the PC for direct connect on the appropriate com port (instead of dial-up connection).

• Set the parameters of the communications software to:

– 9600 baud rate

– 8 data bits

– No parity

– 1 stop bit

– No flow control

• Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by

using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make connection to the PC or laptop

as appropriate for your equipment.

A VT100 terminal program is provided with the ADTRAN Utilities.

1 2 ... 93 94 95 96 97 98 99 100 101 102 103 ... 161 162

Sem comentários

ADTRAN TA 544 Manual de Instruções Página 98